- Make an isosceles right-angled triangle by
getting one corner of the square
fold it
on the opposite lines.
- After making the triangle we will be able
to see a rectangle next to the triangle.
Fold the line joining the triangle
and the
rectangle. After folding, cut along
this
line.
- Unfold the triangle and fold it on the opposite
side, such that it makes another
triangle.
The crossing becomes the centre of
the square.
- Cut along these same lines on the square
about 8 cm from each corner of the
centre.
This will make each corner to have
two leaves.
- Make a hole on the centre.
- Make a small hole near each end of right
leaf. (You make 4 holes)
- If you donf have beads, make two small circular
piece of thick paper about 1 cm in
diameter.
- Get a pin and pass it through the centre
of a bead or through one circular
piece.
- Let the pin pass through the holes of each
leaf one by one. After that, pass
the pin
through the hole on the centre of
the square
sheet and another bead or circular
piece.
- Get this pin containing everything and pin
to the wooden stick by using a hammer
or
to a straw.
- When the pin comes through to the other end
of the stick make sure you bend it
using
a pliers to avoid injury.
- Let the wind propeller face the wind and
observe what happens.
|
|